Decorative strips from the GD series are an aesthetic complement to wooden wall lamellas. Used between the lamellas, they give them contrast, exposing the entire decoration. They also perfectly cover defects and irregularities in the wall.
MAIN PRODUCT FEATURES:
Dimensions - height: 280 cm - width: 3 cm - depth: 0,4 cm
Aesthetics Decorative strips are an exceptionally aesthetic complement to the wall lamellas. They are available in two universal colors that will fit perfectly into almost any interior and color of the lamellas.
High quality materials Decorative GD strips are made of HDF board - a material made of wood fibers, characterized by increased density and high hardness. As a result, GD slats are characterized by greater resistance to mechanical damage and longer life.
Easy and cheap fitting Installation of decorative strips is limited only to sticking them to the wall with a mounting glue. Thanks to this, the installation process is extremely simple and cheap.
2 YEARS WARRANTY For all products from GD series, following the assembly instructions.
To living room
For commercial and service premises
Trimming by the customer
Installation with assembly glue
Designate the place where you want to mount the lamellas. Determine precisely the ideal vertical or horizontal position - the installation of each lamella influences the position of the next.
Glue the mounting strip permanently to the lamella.
Apply mounting glue on the surface.
Attach the lamellas to the wall.
Fitting on a board
Determine precisely the vertical or horizontal position - the installation of each lamella affects the position of the next.
Put the mounting strips on the lamellas.
Screw lamellas to the board.
Precisely mount the board with lamellas on the wall.
Installation with the use of an auxiliary strip
Precisely determine the vertical or horizontal position of the lamellas - the installation of each lamella affects the position of the next one.
Using small screws, screw the mounting strip of the first lamella.
Using the auxiliary rail, determine the location of the next mounting strip.
Screw another mounting strip. Repeat this process for all lamellas.
Apply assembly glue to the lamellas in the place of the milling.